Panasonic DMR-EH75V

Refer to the control reference on page 32.
Press [&, T] to select the channel to customize and then
press [ENTER].
Grid Options menu is displayed.
Items that can be set up differ depending on the situation.
When "SETUP" is selected in step 3 on page 35
SETUP screen is displayed.
The SETUP service allows you to redo the channel settings,
customize the channel line-up and set the TV Guide On Screen e)
system's start-up pattern.
Change system settings
(4 below)
Change channel display
(4 below)
default options
(4 right)
Display setup progress
(4 39)
You can verify any information entered during setup, or completely
redo the setup, for the TV Guide On Screen ®system.
Press [,&, Y] to select "Change system settings" and then
press [ENTER].
The information that was set is displayed, and you are asked to
confirm whether it is correct.
ZIP Co_ _ 11111 IUSA)
Are the above settings correct?
Yes, but my channel lineup !S inco rrect
No, repeat setup process
Press [&, V] to select the message and then press [ENTER].
e"Yes, everything is correct"
- The information that was set will remain intact.
Press [A, y, <1, I_] to select "Next" and then press [ENTER]
to exit the screen.
e"Yes, but my channel lineup is incorrect"
(i) Press [A, y, <1, I_] to select one of the following channel
lineups and then press [ENTER].
@ Press [A, _', 41, I_] to select "Next" and then press
[ENTER].
Then follow the operation instructions given on screen.
e"No, repeat setup process"
- The TV Guide On _>
Screen system setup screen is displayed,
Follow the on-screen prompts to redo the setup (4 23,
step 4).
You can customize the channel line-up. You can easily change
channel line-up should the cable company occasionally revise their
channel assignments.
Press [&, V] to select "Change channel display" and then
press [ENTER].
_ HANNEL
EDITOR
Cable screen
Press [&, V] to select the item and then press [41, _-] or the
numbered buttons to change the setting.
Grid Options
position: Change the position where the channel appears
in the LISTINGS screen (and CHANNEL
EDITOR)
channel: On: Channel is always displayed in
LISTINGS and SEARCH screen
Off: Channel is never displayed in
LISTINGS and SEARCH screen
auto-hide: Display a channel only when program
information is available
service: Change the service for a channel if there is more
than one service available (e.g., cable, over-the-
air, antenna, DirecTV, etc.)
input: Change the input for the channel if there is more
than one input (e.g., Antenna 1, Antenna 2, etc.)
tune channel: Correct the tune channel number using the
remote
re-sort Change the channel order in the LISTINGS
numerically: screen (and CHANNEL EDITOR) to numeric
undo all Reset all channel editor options (and LISTINGS
changes: screen) to their original settings
You can change the size of the Information box etc., scheduled
recording, and scheduled reminder default settings.
Press [J,, V] to select "Change default options" and then
press [ENTER].
Press [&, Y] to select the option and then press [ENTER].
Items for each option are displayed (4 39).
Press [A, V] to select the item and then press [41, _-] or the
numbered buttons to change the setting.
Press [J,, V] to select "done" and then press [ENTER].
RQT8346