Panasonic DMR-XW385

Convenient functions
VQT3F56
76
Changing the unit’s settings
∫ Standby Settings
¾ Power Save in Standby
≥This function cannot be enabled when the DLNA
function is enabled in "Home Network ( DLNA )
Settings" or "Server ( DLNA ) Settings". (> 75)
¾ Automatic Standby
Set the time to automatically turn the unit off.
After the unit has finished operating, the unit will be
turned off once the set time has passed.
¾ Automatic Standby after OTR
If “On” is selected, this unit is turned to standby mode
when this unit is not operated for approximately
5 minutes after completing One Touch Recording
(> 23).
¾ Automatic Standby after Copy
If “On” is selected, this unit is turned to standby mode
when this unit is not operated for approximately
5 minutes after completing copy (> 41).
∫ Remote Control
Change the remote control code on the main unit and the
remote control if you place other Panasonic products close
together.
≥Use “DVD 1”, the factory set code, under normal
circumstances.
1 Select the code, then press [OK].
2 While pressing [OK], press and hold the number button
([1] to [6]) for more than 5 seconds.
3 Press and hold [OK] for more than 5 seconds.
4 Press [OK].
≥Operation is possible only with Panasonic remote controls
with “IR6” printed at the bottom when the remote control
code of this unit is set to “DVD 4”, “DVD 5” or “DVD 6”.
∫ Clock
If the time is not set correctly, use the settings listed in
the method below.
≥Automatic
This unit usually obtains time and date information from
digital broadcasts.
But, if the time is not set correctly, set it to “Off” and
perform “Manual Setting”.
≥Region Selection
Select the region where you live to adjust the standard
time.
≥The time contained in the broadcast signal is UTC
(Universal time, coordinated).
≥Daylight Saving Time
Select time offset from the standard time for Summer
Time.
≥If there is a gap between displayed time and actual
time, set this function.
≥Manual Setting
1 Select “Off” of “Automatic”, then press [OK].
2 Select the item you want to change.
3 Change the setting.
4 Press [OK] when you have finished the settings.
Others
On It will go into the Power Save in Standby
mode.
On Timer “Power Save in Standby” is activated
when the set time comes.
Off It is possible to start quickly from the
standby mode. (Quick Start mode)
Setup
Others
Others
Standby Settings
Enlgish
Remote Control
Clock
PIN Entry
System Update
System Information
DivX Registration
Initialize
Others
Standby Settings
Enlgish
Standby Settings
Power Save in Standby
Enlgish
Automatic Standby
Automatic Standby after OTR
Automatic Standby after Copy
DVD
IR6
DVD
IR6
IR6
Clock
Time Date
Daylight Saving Time Region SelectionAutomatic
Please set the clock.
OK: access RETURN: leave
OK
RETURN
0 00 10
NSW / ACT Automatic
On
11 2010
DMRXW385GL-VQT3F56_eng.book 76 ページ ２０１１年２月８日 火曜日 午後４時３８分