119
FEB 2008Ver. 1.1
DP-C405/C305/C265
(6) Remove the Snap Ring.
(7) Remove 2 E-Rings on the front side.
(8) Remove 4 Bushings on the both sides.
(9) Remove the Gears.
<Replacing the Exit Roller>
(10) Remove the Exit Roller by sliding to the Right
first, and then pulling the Left side out.
(11) Replace with the new Exit Roller.
<Replacing the Feed Roller>
(12) Remove the Feed Roller by sliding to the Right
first, and then pulling the Left side out.
(13) Replace with the new Feed Roller.
To Next Page
Loading...
