Panasonic DP-C405 - Page 353

353
DP-C405/C305/C265
FEB 2008Ver. 1.1
436 G3 RX C DCN received after transmitting
FTT.
Transmitter is defective or incompatible.
Line quality is poor.
438 G3 RX B Received TSI is refusal ID number
as Junk fax.
Note:
This error code is not indicated
on LCD, is recorded for RDS.
Received TSI (ID number) is registered
in Junk fax Address Book.
456 RCV B Received relay transfer request, or
confidential document to distribute
to an end receiving station, or all
confidential mailboxes are used.
457 RELAY
XMT
CONF.
XMT/POLL
B Remote unit does not have
Relayed XMT, or Confidential
Comm. capability.
459 RCV C Failed training in Phase C. Line quality is poor. (Training signal is
distorted due to line noise)
FCB PCB is defective.
490 RCV C Sum of error lines exceeded the
limit (Function Parameter No. 70) of
64 lines.
Line quality is poor.
FCB PCB is defective.
494 RCV C Interval between two EOLs was
more than 10 sec. when receiver
received message data.
Transmitter is defective.
Line quality is poor. (EOL is damaged
due to line noise)
FCB PCB is defective.
495 XMT
RCV
C During reception, CD turned OFF,
or continued ON for long time.
During communication, lost loop -
current.
Line is disconnected.
Transmitter is defective.
FCB PCB is defective.
496 XMT C CS of modem is not able to turn
ON.
FCB PCB is defective.
501 XMT/
RCV(V.34)
B Incompatible Modem on the
Remote unit.
502 XMT/
RCV(V.34)
B, C, D During reception, CD turned OFF,
or continued ON for long time.
During communication, lost loop -
current.
Line is disconnected.
Transmitter is defective.
FCB PCB is defective.
503 XMT/
RCV(V.34)
B, C, D CS of modem is not able to turn ON
during training.
FCB PCB is defective.
Line is disconnected.
504 RCV/V.34
(Polling)
B Polling is rejected from the remote
station.
No polling original is set.
505 XMT/V.34
(Polling)
B Polling XMT is rejected. No polling original is set.
540 XMT ECM B No response after transmitting 3rd
CTC, or DCN received.
Incompatible interface.
541 XMT ECM D No response after transmitting 3rd
EOR, or received DCN.
Line is faulty.
FCB PCB abnormal.
542 XMT ECM D No response to the 3rd RR
transmitted, or received DCN.
Remote unit is abnormal.
543 XMT ECM D T5 timer (60 sec.) elapsed without
MCF.
Remote unit is abnormal.
Fax Information Codes
Code Mode Phase Description of Problem Cause