Panasonic DP-C405 - Page 354

354
DP-C405/C305/C265
FEB 2008Ver. 1.1
550 RCV ECM C Timer between frames in phase C
has elapsed.
Defective remote station.
554 RCV ECM D Transmitted ERR after receiving
EOR.
Faulty line.
FCB PCB abnormal.
555 RCV ECM D Transmitted PIN after receiving
EOR.
Faulty line and Operator Call requested
by RX side.
570 RCV B Password, or machine code did not
match during remote diagnostic
communication.
571 XMT B Remote unit did not have the
remote diagnostic function.
580 XMT B Sub-address transmission to a unit
that has their DIS bit 49 (NSF bit
155) OFF.
Sub-address transmission to a unit that
has no Sub-address function.
581 XMT B Sub-address Password
transmission to a unit that has their
DIS bit 50 (NSF bit 156) OFF.
Sub-address transmission to a unit that
has no Sub-address function.
582 XMT B Sub-address SEP (for Polling)
transmission to a unit that has their
DIS bit 47 (NSF bit 130) OFF.
Sub-address transmission to a unit that
has no Sub-address function.
623 XMT A No original was in the ADF. (Built-in
dialer engaged)
Operator removed the original from the
ADF after dialing was completed.
Original was not set properly in the ADF.
630 XMT or
RCV
(Polling)
B Redial count over. No dial tone detected. Sensor dial tone
is not detected. (Country dependent)
Busy tone is detected. (Country
dependent) T1 timer (35±5 sec) elapsed
without a signal from the receiver.
634 XMT Redial count over with no
response, or busy tone was not
detected.
Note:
U.S.A. and Canadian models
will redial only once if a busy
tone is not detected.
638 XMT Power turned Off with applicable
data in memory, or during
communication.
Power switched off.
Power failure occurred.
712 XMT LAN Unknown email address replied
from the Mail Server.
Mail Server received an incorrect email
address. (Dependent on Server's Mail
application)
714 XMT
RCV
LAN LAN Interface error.
Cannot logon to the LAN.
The 10Base-T/100Base-TX cable is not
connected.
An unexpected LAN problem occurred.
715 XMT LAN TCP/IP connection timed out. Incorrect IP Address is set.
Verify the IP Address, Default Router IP
Address, SMTP Server IP Address.
716 XMT LAN Cannot logon to the LAN. Incorrect SMTP Server IP Address is
set.
No email application is activated on the
Mail Server.
Fax Information Codes
Code Mode Phase Description of Problem Cause