Panasonic DP-C405

437
DP-C405/C305/C265
FEB 2008Ver. 1.1
4.2.3. Fax Service Mode 1 (Function Parameter Setting)
Use the following procedure to change the function parameters.
Set the machine to Service Mode, and press the “9” key on the Control Panel.
↓
Press the “Start” key to enter the F9 Service Mode on the Control Panel.
↓
Select “00 Fax Service Mode” on the Touch Panel display.
↓
Select “01 Function Parameter Setting” on the Touch Panel display.
↓
Select the desired function, or code number on the Touch Panel display, and then select the “OK”
button.
↓
Select the desired code number on the Touch Panel display, and then press the “Start” key on the
Control Panel.
If you wish to input minus value, press the “Reset” key on the Control Panel.
When the “Cancel” button is selected on the Touch Panel display, selected code input will not be
accepted.
↓
If you wish to select another function, select the Tab button on the Touch Panel display, or scroll the
menu with the “”, “” buttons.
↓
Select the “Close” button three time on the Touch Panel display.
↓
Press the “Function”, and the “C (Clear)” keys simultaneously on the Control Panel to exit the Service
Mode.
Function Parameter Table
No. Parameter Selections Function
000 Monitor/Tel Dial Monitor
Tel/Dial
Selects whether the machine starts to TX
automatically during On-Hook dialing.
Monitor : Start to TX after pressing Start
TEL/DIAL : Start to TX automatically
001 Alarm Status Off
Timer
Constant
Selects the No Paper or No Toner alarm status.
OFF : Alarm is disabled.
Timer : Alarm will shut off after 6 seconds.
Constant : Alarm will not stop until "Stop" is pressed
or the error is cleared/corrected.
002 Stop Comm.
JRNL
Off
On
Selects whether the machine prompts to print the
COMM. Journal when the printout condition is set to
INC, and Stop is pressed during communication.
003 Continuous
Polling
Off
Stn
Hub
Selects whether the Continuous Polling feature is
enabled.
Stn : Place the document(s) on the ADF, or Platen,
then press the assigned Program Key to store,
or add the documents into a polled file. (See
Note 1)
Hub : When the polling command is initiated, the
machine will continuously poll originals from
the remote stations until it is interrupted by
pressing "Stop".