Panasonic DP-C405 - Page 440

440
DP-C405/C305/C265
FEB 2008Ver. 1.1
024 CED Frequency 1080 Hz (non ITU-T)
2100 Hz
Selects the CED frequency 2100/1080 Hz
025 COMM. Start-Up First
Second
Selects the communication start-up condition (XMT
and Polling).
(Used when Echo Suppression is disabled.)
026 Non-Standard Off (Invalid)
On (Valid)
Selects own mode (Panafax mode).
027 Short Protocol B Off (Invalid)
On (Valid)
Selects the short protocol mode.
028 Short Protocol D Off (Invalid)
On (Valid)
Selects the short protocol mode. When activated, it
allows the machine to automatically store the modem
speed for each Auto Dial Number.
029 Remote
Diagnostics
Off (will not accept)
On (accepts)
Selects whether the machine accepts Remote
Diagnostics from the service station.
030 CED & 300 bps 75 ms
1 sec
Selects the pause interval between the CED, and the
300 bps signal.
(Used when Echo Suppression is disabled.)
031 RTC = EOL x 12 Off (EOLx6)
On (EOLx12)
Selects the RTC signal, EOLx6 or EOLx12.
032 V34 TX Start 2400-33600bps Selects the transmission modem start speed for V.34
communication, 33600-2400 bps.
Press “ ” or “ “ to select the symbol rate.
033 V34 RX Start 2400-33600bps Selects the receiving modem start speed for V.34
communication, 33600-2400 bps.
Press “ ” or “ “ to select the symbol rate.
034 V34 TX SR 2400-3429sr Selects the transmission symbol rate for V.34, 3429/
3200/3000/2800/2400 sr.
Press “ ” or “ “ to select the symbol rate.
035 V34 RX SR 2400-3429sr Selects receiving symbol rate for V.34, 3429/3200/
3000/2800/2400 sr.
Press “ ” or “ “ to select the symbol rate.
036 Not Used
037 Protocol Display Off (not displayed)
On (displayed)
Selects whether to display the modem speed during
communication.
(Press the Job Status Key to display)
038 Not Used
039 Flash Time 50 ms
~
1000 ms
Selects the pause interval before activating the Flash
key.
040 Flash Time
(PSTN)
50 ms
~
1000 ms
Selects the pause interval before activating the Flash
key.
(For Germany, Austria and Czech)
041 Pause Time 1 = 1 sec.
~
10 = 10 sec.
Selects the pause interval from 1 sec. ~ 10 sec. for
dialing through a switchboard, or for international
calls.
042 Not Used
043 Redial Interval 0 = no waiting
~
15 = 15 minutes
Selects the redial interval from 0 to 15 minutes in 1
minute steps.
Function Parameter Table
No. Parameter Selections Function