Panasonic DP-C405 - Page 442

442
DP-C405/C305/C265
FEB 2008Ver. 1.1
068 NYSE Fax
Forward
(USA and
Canada Only)
Off
On
Selects whether the machine will forward the
incoming, and outgoing faxes to a specified station.
Note:
Once this parameter is activated, Fax Forwarding
via Fax Parameter No. 054 is automatically
disabled, an Access Code of "0000" is
automatically assigned and Fax Parameter No.
038 has a new setting added called "NYSE".
069 NYSE Local Print
(USA and
Canada Only)
Inc
On (Always)
Selects the printing condition for the incoming faxes
after FAX Forwarding.
INC. : Prints only if FAX Forwarding fails.
ON : Always prints.
070 Line Error 128 lines
256 lines
512 lines
1024 lines
2048 lines
Off (will not disconnect
line)
1. Selects the line disconnect condition during
reception. If the number of line errors exceed this
setting, the unit will disconnect the line.
2. Selects the transmit condition of RTP/PIP, or RTN/
PIN.
(Available if No. 73 Error Detect is set to "LINES")
(See Note 2)
071 Total Error 5
10
15
20
Selects the transmit condition of RTP/PIP, or RTN/
PIN.
(Available if No. 73 Error Detect is set to "RATE".)
(See Note 3)
072 Continuous Error Off
3
6
12
Selects the continuous total error criteria of Off/3/6 or
12 lines in Standard mode. If continuous total error
exceeds this setting, the unit will transmit RTN/PIN.
(Available if No. 73 Error Detect is set to "RATE".)
073 Error Detect Lines
Rate
Selects the error detect condition Lines/Rate.
074 RTN Receive Discon
Conti
Selects whether to disconnect the phone line, or to
continue when "RTN" is received.
075 Coding MH (MH only)
MR (MH or MR)
M M R ( M H , M R , o r M M R )
JBIG (MMR, MR, MH, or
JBIG)
Selects the coding scheme.
076 Batch TX
(USA and
Canada Only)
Off
On
Selects whether the batch transmission is available.
077 RX JAM Length Off (unlimited)
2 m
Selects the maximum length of a received document
that can be printed.
078~
079
Not Used
080 Original Lead
Edge ADF
-99
~
+99
Adjusts the distance between the scanning sensor
ON position, and the scanning start position.
081 Original Tail Edge
ADF
-99
~
+99
Adjusts the distance between the scanning sensor
OFF position, and the scanning end position.
082 JAM Length 1 m
2 m
Selects the maximum length of the original that can
be scanned.
083 Not Used
Function Parameter Table
No. Parameter Selections Function