Panasonic DP-C405

84
FEB 2008Ver. 1.1
DP-C405/C305/C265
(2)USB Port
The machine's Firmware can be updated using your Notebook PC via an USB Port. This method is
convenient when you brought a Notebook PC into the customer's site for the purpose of updating the
firmware.
Refer to the Firmware Update Operating Instructions, and Section 2.11.3. for additional details.
(3)SD Memory Card (New Method: Convenient Method without a PC)
The machine's Firmware can be updated using the Master SD Memory Card in the SD Card Slot in
Front of the machine (not the SD Card Slot on the SC PCB). This method is convenient when you are
visiting the customer's site for the purpose of updating the firmware without a PC.
The Master SD Memory Card can be created by copying the Firmware using the SD Memory
Firmware Writing Tool Software, and a PC with SD Memory Card Slot, or with an SD Memory Card
Reader & Writer.
Just a single Master SD Memory Card is sufficient to update the SC PCB with the Standard, or with all
Optional configurations (PS and Fax options included), as long as all the necessary firmware codes
are stored onto the card. The easiest way is to use “Auto Mode” for updating all necessary firmware at
once.
Refer to the Firmware Update Operating Instructions, and Section 2.11.5. for additional details.
Caution:
Before updating the Firmware using the SD Memory Card, remove the PCMCIA/PC Card Adapter
from the PCMCIA/PC Card Slot in Front of the machine.
2.11.2. Updating through a LAN Port
The firmware code can be easily updated when the main unit is connected to a LAN.
If the unit is not connected to a LAN, the Network Firmware Update Tool can be used by connecting to the
machine using a Cross Cable.
Caution:
Before proceeding with the Firmware Update, clear all Fax or Internet Fax jobs first, or the Firmware will
not update properly. Follow the steps below to perform All Job Clear.