Panasonic DP-C405

86
FEB 2008Ver. 1.1
DP-C405/C305/C265
5) Confirmation
After the update is completed, the machine reboots itself and returns to standby.
Confirm the F5 & F6 parameters according to the printed lists in Step 3) above if the settings are
different.
Note:
1. Manual mode must be used, when updating the designated version of the firmware, or changing the
type of the firmware.
Please refer to the Section 2.2, “Setting up the Network Firmware Update Tool, File Selection
Tab” of the Operating Instructions.
2. While updating the firmware code, the display may become garbled, however, it will return to normal
upon completion of the firmware update.
3. If the firmware update fails, and the unit does not boot up, the Network Firmware Update Tool will
not be able to transfer the firmware code. If this occurs, refer to Section 2.11.7. “Firmware
Emergency Recovery”.
4. The suffix “_xx” for the Folder Name, or File Name may not exist depending on the destination
location.
2.11.3. Updating through USB Port
If the device is not connected to the LAN, upgrade the firmware code using the USB Port.
Caution:
Before proceeding with the Firmware Update, clear all Fax or Internet Fax jobs first, or the Firmware will
not update properly. Follow the steps below to perform All Job Clear.
1. Press the “Function”, “Copy”, and the “3” keys simultaneously on the Control Panel.
2. Input the password, and select the “OK” button to enter the Service Mode (default password is
00000000).
3. Press the “9” key on the Control Panel, and then press the “Start” key to enter the F9 Service Mode
(Unit Maintenance).
4. Select “00 FAX Service Mode” on the Touch Panel display.
5. Select “06 RAM Initialize“ on the Touch Panel display.
6. Select “09 All Job Clear” on the Touch Panel display, and then select the “Yes” button.
After clearing the jobs, the machine reboots automatically, and returns to the standby mode.
1) Install the Local Firmware Update Tool to your PC
The Tool can be downloaded from your sales company's Web site, or the PCC ONC Service Web site.
Please refer to the Operating Instructions of the Tool for details.
2) Preparing the Firmware Code
Double click the appropriate Destination Shortcut Batch File, and copy the Firmware Code File on the
CD-ROM to the Firmware Data Folder in your PC, or access onto the Service Web site to download the
latest Tool and Firmware Code. Note that the files in the Archive will be extracted automatically into the
designated folder when the Archived file (.exe) is Double-clicked.
Example:
From:
Destination Shortcut Batch File: D:(CD-ROM Drive) \ xFirmware \ USA.bat
Firmware Code File: C405_C305_C265_xx_xxxxxxxx_xx.exe
To:
Firmware Data Folder: C:\ Panasonic \ Panasonic-FUP \ Data
3) Preparing the Main Unit for the Firmware Upgrade
Before starting, print the F5/F6 Parameters List (Copy Service Mode F9-03-00).
Important: DO NOT connect the USB Cable yet.
Enter into Service Mode F9-07-01 (Update From USB) to enable the unit to accept the programming