Feature Code Selection
Power save #403 To set the length of time before the unit enters power save mode.
M1N “1min” (default)
M2N “5min”
M3N “15min”
M4N “30min”
M5N “45min”
Note:
R During power save mode, the unit needs to preheat the fuser unit before it can
begin printing.
Contrast hold
#462 To hold the previous contrast setting.
M0N “DISABLED” (default)
M1N “ENABLED”
Note:
R This feature is not available for scanning contrast.
Default operation
mode
#463 To select the default operation mode when the selected time of the mode timer
(feature #464) elapses.
M1N “COPY” (default)
M2N “FAX”
Note:
R You cannot select scan mode using this feature.
Mode timer #464 To set the timer before returning to the default operation mode (feature #463).
M0N “OFF”
M1N “30s”
M2N “1min” (default)
M3N “2min”
M4N “5min”
Counter view for
departments
#479 To view the count number of copies/prints for departments. See page 103 for
details.
Toner save #482 To set the toner save feature. When “ON” is selected, the toner cartridge will last
longer.
M0N “OFF” (default)
M1N “ON”
Note:
R This feature may lower the print quality by reducing toner consumption.
R This setting is valid for copying, and when the unit prints reports/lists.
R This setting is invalid for printing received faxes.
77
12. Programmable Features
To Next Page