Panasonic DP-MB251CX - Page 78

12.1.2 Fax features
Feature Code Selection
TEL/FAX delayed
ring count
#212 If you use an extension telephone in TEL/FAX mode, select the desired number
of times the extension telephone rings before the unit answers the call.
M1N “1”
M2N “2” (default)
M3N “3”
M4N “4”
M5N “5”
M6N “6”
M7N “7”
M8N “8”
M9N “9”
Note:
R See page 61 for details.
Sending report
#401 To print a sending report.
M0N “OFF”: Sending reports will not be printed.
M1N “ON”: A sending report will be printed after every fax transmission.
M2N “ERROR” (default): A sending report will be printed only when fax transmission
fails.
Automatic journal
report
#402 When “ON” is selected, the unit will print a journal report automatically after every
30 new fax transmissions and receptions (page 58).
M0N “OFF”
M1N “ON” (default)
Manual answer
mode
#404 To change the receiving mode in the manual answer setting (page 61).
M1N “TEL” (default)
M2N “TEL/FAX”
Default fax
resolution
#405 To change the default resolution setting for fax.
M1N “STANDARD” (default): For normal-sized characters.
M2N “FINE”: For small-sized characters.
M3N “SUPER FINE”: For very small-sized characters.
M4N “PHOTO”: For photographs, shaded drawings, etc.
Note:
R Using the “FINE”, “SUPER FINE” and “PHOTO” settings will increase
transmission time.
Duplex print
setting for fax
reception
#407 To set the duplex print for fax reception.
M0N “OFF” (default)
M1N “LONG EDGE”
M2N “SHORT EDGE”
Overseas mode #411 If you cannot send a fax overseas even if the number is correct and the line is
connected, activate this feature before sending the fax.
This feature improves the reliability by reducing the transmission speed.
Calling charges may be higher than usual.
M0N “OFF”: Deactivates this feature.
M1N “NEXT FAX”: This setting is effective only for the next attempted fax
transmission. After transmission, the unit will return to the previous setting.
M2N “ERROR” (default): When the previous fax transmission fails and you want to
re-send the document.
Note:
R This feature is not available for broadcast transmission.
Delayed send
#412 To send a fax at a specific time. See page 58 for details.
78
12. Programmable Features