Feature Code Selection
Font number in
PCL
#769 To set the font number to be used in PCL printing. The unit assigns a number to
each font.
1. MMENUN A MBNM7NM6NM9N A MSETN
2. Enter the font number from “000” to “056”, using the dial keypad.
R The default setting is “000”.
3. MSETN A MMENUN
Note:
R If the font source in PCL (feature #768 on page 84) is set to “DOWNLOAD
FONT”, the default setting is “001”.
R To print the font list, see page 100.
Font pitch/point in
PCL
#770 To set the font pitch/point to be used in PCL printing.
1. MMENUN A MBNM7NM7NM0N A MSETN
2. Enter the font pitch from “00.44” to “99.99”, or the point from “004.00” to
“999.75”, using the dial keypad.
R The default pitch is “10.00” and the default point is “012.00”.
R Whether this step is font pitch or point depends on the font number
selected in feature #769 (page 85).
3. MSETN A MMENUN
Symbol set in PCL
#771 To set the symbol set to be used in PCL printing.
1. MMENUN A MBNM7NM7NM1N
2. Press MCN or MDN repeatedly to display the desired symbol set. A MSETN
A MMENUN
Line breaks in PCL #772 To set each behaviour when receiving CR, LF, and FF codes.
M1N “CR/LF/FF” (default): CR=CR, LF=LF, FF=FF
M2N “CR+LF/LF/FF”: CR=CR+LF, LF=LF, FF=FF
M3N “CR/CR+LF/CR+FF”: CR=CR, LF=CR+LF, FF=CR+FF
Auto continue
mode
#773 To set the length of time before the unit recovers if a memory overflow occurs.
M1N “OFF” (default)
M2N “20s”
M3N “30s”
M4N “60s”
M5N “90s”
M6N “120s”
Data timeout
#774 To change the data timeout setting. The unit will automatically print the remaining
data in memory when the computer does not send data to the unit during the set
time.
1. MMENUN A MBNM7NM7NM4N A MSETN
2. Enter the desired data timeout setting from “005” seconds to “600” seconds,
using the dial keypad.
R The default setting is “060” seconds.
3. MSETN A MMENUN
Mutual A4/letter
print
#776 This feature allows printing in A4-size even if letter-size recording paper is loaded,
and vice versa. When “ON” is selected, printing is possible between A4/letter-size.
M0N “OFF”
M1N “ON” (default)
Note:
R This feature is not available for the multi-purpose tray.
85
12. Programmable Features
To Next Page
Loading...
