13
VQT3Y04
w Inserting the battery
Install the battery by inserting it in the
direction show n in the figure.
p Insert the battery until it clicks and locks.
w Charging the battery
DC input terminal
C onnect the AC cable to the AC
adaptor, then the AC outlet.
C onnect the AC adaptor to the DC input
terminal [DC IN].
p The status indicator will flash red
for
approx. 2 seconds (off for approx. 1 second, on
for approx. 1 second),
indicating that
charging has begun.
It will turn off when the charging is
com pleted.
w Inserting/re m o v ing an SD card
p Check that the access lam p has gone off.
1) O pen the SD card cover and insert/
rem ove the SD card into/from the card
slot .
p Face the label side in the direction
show n in the illustration and press it
straight in as far as
it will go.
p Press the center of the SD card and then
pull it straight out.
2) Securely close the SD card cover.
p Securely close it until it clicks.
Quick Guide
A ccess lam p [ACCESS]
p W hen this unit is accessing the SD
card or built-in memory, the access
lam p lights up.
To Next Page
Loading...
