76
VQT3K06
3
Select the media you wish to dub, then press the ENTER button.
≥ When using the battery, the LCD monitor turns off after about 5 seconds. Press the cursor
button to turn the LCD monitor on.
4 Dub through operations on the Blu-ray disc recorder or high-
definition (AVCHD) compatible DVD recorder.
≥ Do not press the ENTER button of the unit during dubbing.
≥ Do not use any other USB cables except the supplied one. (Operation is not guaranteed
with any other USB cables.)
≥ When this unit is connected to a Panasonic Blu-ray disc recorder or a DVD recorder using
a USB cable while the unit is turned on, power is also supplied from the connected
equipment to this unit.
≥ For details on dubbing and playback methods, read the operating instructions of the
Blu-ray disc recorder or DVD recorder.
≥ When you connect the unit to a Blu-ray disc recorder, a dubbing operations screen may
appear on the television connected to the Blu-ray disc recorder. In this case as well,
perform the operations of steps 1 to 4.
≥ You cannot change the mode of the unit or turn off the unit while it is connected to a Blu-ray
disc recorder or DVD recorder. Disconnect the USB cable before performing either of these
operations.
≥ If the battery runs down during dubbing, a message will appear. Operate the Blu-ray disc
recorder to cancel the dubbing.
About the screen indication of the unit
≥ When the unit is accessing the SD card, card access icon ( ) appears on the unit
screen or the access lamp is on.
≥
When the unit is accessing the built-in memory, built-in memory access icon ( )
appears on the unit screen or the access lamp is on.
≥ Be careful not to disconnect the USB cable, AC adaptor or battery while the unit is
accessing media, as this may result in the loss of recorded content.
HDC-SD40&TM40EB-VQT3K06_mst.book 76 ページ ２０１１年２月８日 火曜日 午後６時８分
To Next Page
Loading...
