33
Display Unit (Including Main Block) Replacement
Be sure to disconnect the power cable of the main block (POS Workstation) and
confirm the power is “OFF” before the operation below.
■ When fixing parts that use VESA mounts are installed
1
Before removing the cable cover, tilt the display unit
to the horizontal position.
Put your hands on both sides of the underside of the
cable cover, and while holding up the cable cover,
slide it toward you to remove.
●
Try not to hold the operation surface side of the
operator’s display when holding up the cable
cover.
●
If the cable cover cannot be easily removed, hold
the base cable cover to remove it.
●
Do not pull the cable cover forcefully. It can cause
damage of the cable cover.
Base cable cover
2
Disconnect all the cables, including the DCIN cable,
connected to the display unit.
English
To Next Page
Loading...
