Panasonic JS-970 Series - How to Remove Internal Battery Pack

41
How to Remove Internal Battery Pack
(for Models with Internal Battery Pack)
The battery pack embedded in the equipment is replaceable; however, make sure
to contact a designated contractor for removal and installation.
Be sure to disconnect the power cable of the main block (POS Workstation) and
confirm the power is “OFF” before the operation below.
■ Detach the stand, etc. from the display unit, and separate the main
block.
1
First, remove the HDD and SD Memory Card from
the main block.
●
In removing the HDD, unscrew the screw securing
the HDD tray.
2
Unscrew four screws securing the chassis on the
top side of the main block.
Raise and invert the chassis, and lay it on a flat
surface.
3
Unscrew three screws securing the battery pack.
Disconnect the battery pack connector from the
main substrate to remove the battery pack.
English