52
Cleaning of Filter
Be sure to disconnect the power cable of the main block (POS Workstation) and
confirm the power is “OFF” before the operation below.
The cleaning period is a guideline, and frequent cleaning is recommended.
■ Removing and cleaning the filter
Clean the filter every two weeks following the procedure below.
1
Follow step 1 in “Operator’s Display Replacement”
to remove the cable cover. (
pages 37, 39)
2
While holding down the whole surface of the filter,
slide the filter forward to remove.
●
Do not use excessive force to open the filter.
Filter
3
Remove any dust from the filter and cable cover with
a vacuum cleaner.
●
Wipe away any dirt using a moistened firmly
wrung-out cloth.
●
Do not use a pot cleaner or scrubbing brush.
●
It is recommended that you also clean other vent
areas at the same time.
■ Installing the filter
1
Align the filter to the filter installation section of
the main block, and while holding down the whole
surface of the filter, slide the filter backward to
install.
●
Firmly press the filter in until the back latch on its
near side clicks.
2
Follow step 6 in “Operator’s Display Replacement”
to install the cable cover. (
page 38, 40)
To Next Page
Loading...
