4 Installation
4.1 Required Space Around the Scanner
In order to ensure proper operation, install the unit maintaining the proper distances from surrounding
objects, as shown in the following illustration.
210 mm*¹
(8.3 in.)
320 mm*¹
(12.6 in.)
[Top View]
*1 Clearance required to set the feed tray and exit tray.
Notice
• Do not move the unit immediately from a cold place to a warm place. It may cause condensation,
which may damage the unit. Using the unit immediately will cause the document scanning to be
imperfect. To avoid this, clean the inside rollers with a dry and soft cloth, leave the unit in a warm
place for 1 or 2 hours, and then use the unit after you make sure that the inside of the unit has dried.
• Do not place the unit in extremely high temperature such as near by heat sources or etc.
• This equipment is not suitable for use in locations where children are likely to be present.
4 Installation
19
To Next Page
Loading...
