6.3.2.3 Using the Mixed Batch Card Guide
Set paper documents on the feed tray, and a card on the mixed batch card guide respectively.
• The card set on the mixed batch card guide is fed after completing the paper document scanning.
• The mixed batch card guide is suitable for the following card type.
ISO format card:
Size: 85.6 mm × 54 mm (3.4 in. × 2.1 in.)
Thickness: 0.76 mm (0.03 in.)
Embossed card up to 1.24 mm (0.049 in.)
• Set the card in landscape orientation.
• A maximum of 3 cards can be set in the mixed batch card guide.
• Ensure that the embossed portions of cards do not stick together.
• If acceptable results cannot be obtained, try changing the scanning orientation or reversing the scan face
of the card, and then perform scanning again.
Note
• When using the mixed batch card guide, the document guides cannot be adjusted to less than A5
size.
• Make sure that the total height of the paper on the feed tray does not exceed 2 mm (0.08 in.). (This is
equivalent to about 20 sheets at 80 g/m² [21 lb.].)
6.3.2 Mixed Batch Card Guide
46
To Next Page
Loading...
