Panasonic KV-S1037X - Preparation of Network PC Mode

6.4.4 Preparation of Network PC mode
Registering Job Setting List in Image Capture Plus
1. Start Image Capture Plus.
• Select [Image Capture Plus Standard] as the application mode.
2. On the [Scan Setting] menu, enable [Job Scan Mode].
Note
• You cannot enable [Job Scan Mode] if any documents are left in [Document List].
3. On the [Scan Setting] menu, click [Job Setting List].
4. Click [Add], and specify the settings.
• The top 10 jobs in the Job Setting List are available for Network PC Mode.
5. Click [Save Setting] to save the settings.
Registering the settings to single touch scan button
1. Launch Configuration Web (page 62).
2. Select the [Scan] tab, and then click [Single Touch Scan].
6.4.4 Preparation of Network PC mode
55