6.4.3 Preparation of USB mode
Selecting the behavior of push scan
This setting is available for all push scanning in USB mode.
1. Double click the ( ) icon in the notification area of the task bar to open the Scan Button Setting Tool.
• In Windows 8, open the Scan Button Setting Tool on the desktop screen.
2. Select [Single Touch Scan Button (1-3)].
3. Select [Image Capture Plus] as the application to start up.
Registering Job Setting List in Image Capture Plus
1. Start Image Capture Plus.
• Select [Image Capture Plus Standard] as the application mode.
2. On the [Scan Setting] menu, enable [Job Scan Mode].
Note
• You cannot enable [Job Scan Mode] if any documents are left in [Document List].
3. On the [Scan Setting] menu, click [Job Setting List].
4. Click [Add], and specify the settings.
5. Click [Save Setting] to save the settings.
Registering Scan Button Setting in Image Capture Plus
1. Press a desired single touch scan button for more than 2 seconds.
• The [Application Settings] dialog box appears. If it does not appear, set the "Type" for the desired
single touch scan button to [USB] in the Configuration Web as follows.
i. Launch Configuration Web (page 62).
ii. Select the [Scan] tab, and click [Single Touch Scan].
iii. Select the [USB] for "Type" of the desired single touch scan button.
iv. Click [Submit].
v. Press the Start/Stop button (
) to complete registering the settings.
2. Select the [Job Scan] for "Operation", and then select a job from Job Setting List.
3. Click [OK] to save the settings.
6.4.3 Preparation of USB mode
53
To Next Page
Loading...
