Panasonic KX-F50

Verifying your OGM
Press the OGM PLAY button.
The unit replays your outgoing message.
GM PLE? If you want to change your OGM, perform the
| operation on page 1-13 again. The previous
message will be automatically erased and new
message will be recorded.
Suggested message
Record your OGM referring to the examples below.
“This is (your name, business and/or telephone number). We are out now. To send а
fax, start transmission. To leave a message, speak after the long beep. Thank you."
“This is (your name, business and/or telephone number). We аге out now. To send a
fax, start transmission. To leave a message, speak for up to 1 minute after the long
beep. Thank уои."
You can choose from two types of recording time of incoming messages. When the
unit is in the "VOX" position, the recording time is unlimited, and when in the
“1 MIN" position, the recording time is limited to 1 minute. The two examples above
correspond to these two conditions.
The unit is preprogrammed to the "VOX" position. To change the recording time,
see page 4-5.
OGM backup
After your OGM is recorded on the microchip memory, it is recorded onto the tape
from the microchip as a backup.
If a power failure takes place or the power switch is turned off, the OGM recorded
on the microchip will be erased. However, after the power is restored, the unit will
automatically re-record the OGM onto the microchip using the OGM recorded on
the tape. You need not re-record your OGM.
Re-recording of OGM
When you replace the cassette tape with a new one or you use the opposite side
(side-2), you have to record an OGM again. See page 1-13.