Panasonic KX-F50

Voice Contact
Initiating voice contact
While you are transmitting or receiving a document, you may wish to speak to the
other party. If the other party’s unit is equipped with a voice contact feature, you can
initiate voice contact and notify the other party that you wish to speak after the
transmission/reception is completed. This saves the extra expense and time of
making a subsequent telephone call to discuss information sent over the fax.
Press the MONITOR button or lift the
handset while transmitting or receiving
the documents.
MONITOR
When the other party answers, start
speaking using the handset.
If you initiate voice contact while transmitting
documents, you can speak after all the
documents have been transmitted.
If you initiate voice contact while receiving
documents, you can speak after receiving the
current page of the documents.
Receiving a request for voice contact
If the other party initiates voice contact during transmission or reception, your unit
will beep after the fax is completed.
When the beep sounds, lift the handset
and start speaking.
Note:
If you do not answer within 10 seconds after hearing several beeps indicating the
request for voice contact, one of the followings occurs:
e When you have set the unit to the TAD/FAX mode, the unit plays back your OGM
and records the voice-message on the tape.
e When you have set the unit to the FAX mode, the line is disconnected.
eWhen you have set the unit to the TEL mode, the line is disconnected.
2-8