Panasonic KX-F50

Operating as an Answering Device from а
Remote Phone
You can retrieve the incoming messages and re-record your outgoing message
from a remote location with a touch tone telephone.
The following features are available on this unit.
e Message playback
e Newly recorded message playback (Memory Playback)
ФВаск space and skip forward
e Recording a marker message
eResetting the tape for future messages
e Room monitor
eRe-recording the OGM (outgoing message)
e Skipping the OGM for ICM (incoming message) recording
These operations are available only in TAD/FAX mode. If your unit is in the TEL
mode, call your unit and wait for 15 rings. The unit will switch to the TAD/FAX mode.
Toll saver
When you call the unit from a remote location, the number of rings tells you if there
are any new voice-messages.
If the unit answers on the 1st ring, there is at least one new message recorded.
If the unit answers on the 3rd ring, there are no new messages recorded.
Hang up immediately when you hear the 2nd ring. The 2nd ring indicates that there
are no new messages. This will save you the toll charge for the call.
The toll saver works only when TAD RING COUNT is set to the Toll Saver position.
See page 4-6.
Summary of remote control functions
Call your unit. Skip OGM (see page 3-9)
Use the following functions as needed.
Enter your REMOTE TAD ID
during the OGM.
1
2
11 Back Space (see page 3-7)
1 Skip Forward (see page 3-7)
Resetting Tape (see page 3-8)
Memory Playback (see page 3-6)
JKL
5 || Room Monitor (see page 3-8)
3
The unit plays back all
recorded messages.
OGM Re-recording (see page 3-9)
ea
Stop
OGM
Recording
==
(see
page
3-9)
3-4