Panasonic KX-F50

Printing Reports and Lists
Individual Transmission Report (TX Report)
One of the following choices are available:
ON mode: The report is always printed to let you know if the transmission is successful or not.
ERROR mode: The report is printed only when a transmission error occurs.
OFF mode: The report is not printed whether the transmission is successful or not. (Default)
<< TX REPORT >>
OTHER FACSIMILE = PANASONIC
PAGES = BØ RESULT = NGC O3 )
ll Transmission error codes Ш Setting PRINT TX REPORT mode
Description
| ок | Successful transmission
NG The STOP/CLEAR button
was pressed to interrupt the
operation.
1 Press the PROGRAM button.
The PROGRAM indicator lights.
2 Press “Ж”, then press "11" for the
transmission report mode setting.
3 Press “1”, "2" or "3", then press the
SET button to store your selection in
memory.
Selection is as follows:
Press “1” to set to ON mode.
Press “2” to set to ERROR mode.
Press "3" to set to OFF mode.
Document jammed or not fed
into the unit properly.
Check the paper path and try
again.
Transmission error. Try again.
4 Press the PROGRAM button to end
the operation.
The PROGRAM indicator goes out.
4-1