Panasonic KX-F50

Troubleshooting Guide
Facsimile
PROBLEM
| cannot receive documents
automatically.
CAUSE & REMEDY
eMake sure recording paper is installed
properly.
eMake sure the RECEIVE MODE of the
unit is set to TAD/FAX or FAX mode and
not to TEL mode.
eShorten your OGM.
Recording image is faint and І cannot
read it well.
eThe sender transmitted a faint document.
Request him to transmit the cleared
document (e.g. copied one) again.
The other party complains that the
letters on the document are distorted.
The START/COPY indicator flashes for
about 40 seconds after the unit
receives a call automatically, but
nothing is recorded.
When | receive or copy a document that
has a dark background or contains
photographs, the unit produces a high
pitched noise.
The unit does not operate properly.
Problems when receiving international
facsimiles.
eif your line has special telephone service
such as call waiting, it may have been
activated by another telephone call.
Connect the unit to a line that does not
have such service.
eBe sure any other telephone is not
connected to the same line as your unit.
eThe caller hangs up during or
immediately after playing back your
OGM. This may occur if the disconnect
signal is not transmitted from the central
office.
eThis is quite normal.
eTurn the POWER switch off, then turn it
on again.
eShorten your OGM to 10 seconds or less.
eFAX RX SPEED may need to be set to
4800 bps. See page 4-4.