Panasonic KX-HDV130 - Page 12

For details about the individual network settings that can be configured via the unit, refer to the Operating
Instructions on the Panasonic Web site (→ see Introduction).
For details about configuring network settings via the Web user interface, see 4.3.1 Basic Network
Settings.
To configure IP Mode (IPv4, IPv6, IPv4&IPv6)
KX-HDV130/KX-HDV230
[In standby mode]
1.
2.
[ ]/[ ]: "System Settings" →
OK
3.
[ ]/[ ]: "Network Settings" →
OK
4.
[ ]/[ ]: "IP Mode Select" →
OK
5.
[ ]/[ ]: "IPv4" / "IPv6" / "IPv4&IPv6" →
OK
• The initial value is IPv4.
KX-HDV330/KX-HDV430
[In standby mode]
1.
Tap
/ → "System Settings"
2.
Tap "Network Settings"
3.
Tap / → "IP Mode Select"
4.
Tap "IPv4"/"IPv6"/"IPv4&IPv6"
• The initial value is "IPv4".
Configuring the Network Settings Using IPv4
To configure network settings automatically
KX-HDV130/KX-HDV230
[In standby mode]
1.
2.
[ ]/[ ]: "System Settings" →
OK
3.
[ ]/[ ]: "Network Settings" →
OK
4.
[ ]/[ ]: "IPv4 Settings" →
OK
5.
[ ]/[ ]: "DHCP" →
OK
6.
[ ]/[ ]: "Auto" →
OK
• Select Manual to enter the addresses for DNS1 (primary DNS server) and, if necessary, DNS2
(secondary DNS server) manually, and then press
OK
.
KX-HDV330/KX-HDV430
[In standby mode]
1.
Tap
/ → "System Settings"
2.
Tap "Network Settings"
1.1.3 Basic Network Setup
12 Administrator Guide Document Version: 2017-07