Panasonic KX-HDV130

Auto DNS via DHCP
Description Selects whether to enable or disable the DNS server obtained by
DHCPv6.
Note
• This setting is available only when [Connection Mode] is set
to [DHCP].
Value Range
• Yes: Use DNS obtained by DHCPv6
• No: Not use (use static DNS)
Default Value Yes
Configuration File Reference DHCP_DNS_ENABLE_IPV6
DNS1
Description Specifies the IP address of primary DNS server for IPv6.
Value Range Max. 39 characters
n:n:n:n:n:n:n:n [n=0-FFFF, abbreviation available]
Default Value Not stored.
Configuration File Reference USER_DNS1_ADDR_IPV6
DNS2
Description Specifies the IP address of secondary DNS server for IPv6.
Value Range Max. 39 characters
n:n:n:n:n:n:n:n [n=0-FFFF, abbreviation available]
Default Value Not stored.
Configuration File Reference USER_DNS2_ADDR_IPV6
4.3.2 Ethernet Port Settings
This screen allows you to change the connection mode of the Ethernet ports, LLDP and the VLAN settings.
Note
• When you change the settings on this screen and click [Save], after the message "Complete" has
been displayed, the unit will restart automatically with the new settings applied. If a unit is on a call
when "Complete" has been displayed, the unit will restart after the unit returns to idle.
4.3.2 Ethernet Port Settings
Document Version: 2017-07 Administrator Guide 71