Note
The "Embedded Web" settings can also be configured with the following procedure.
When the unit is in standby mode,
1.
Tap / → "System Settings"
2.
Tap
/ → "Network Settings"
3.
Tap / → "Embedded Web"
Configuring Settings from the Web User Interface
To close the unit’s Web port
1. In the Web user interface, click [Web Port Close].
2. Click OK.
Note
• The Web port of the unit will be closed automatically in the following conditions:
– 3 consecutive unsuccessful login attempts occur.
• The Web port can be set to stay open continuously, through Configuration file programming (→ see
"HTTPD_PORTOPEN_AUTO" in 5.3.8 HTTPD/WEB Settings). However, please recognize the
possibility of unauthorized access to the unit by doing so.
Access Levels (IDs and Passwords)
2 accounts with different access privileges are provided for accessing the Web user interface: User and
Administrator. Each account has its own ID and password, which are required to log in to the Web user
interface.
Account Target User
ID
(default)
Password
(default)
Password Restrictions
User End users user -blank-
(NULL)
• When logged in as User, you can
change the password for the
User account (→ see 4.4.2 User
Password Settings).
• The password can consist of 6 to
64 ASCII characters (case-
sensitive) (→ see Entering
Characters in 1.1.6.4 Accessing
the Web User Interface).
Administrator Network
administrators,
etc.
admin adminpass
• When logged in as Administrator,
you can change the password for
both the User and Administrator
accounts (→ see 4.4.3 Admin
Password Settings).
• The password can consist of 6 to
64 ASCII characters (case-
sensitive) (→ see Entering
Characters in 1.1.6.4 Accessing
the Web User Interface).
1.1.6 Web User Interface Programming
Document Version: 2017-07 Administrator Guide 19
To Next Page
Loading...
