Panasonic KX-NS500 - Page 189

3. "Continue Offline Programming (Open - Offline Mode)
*1
The PBX's system data file
• KX-TDA100/KX-TDA200: DSYS
• KX-TEx824: xxxxxx.kea
*2
The
software version for KX-TDA100/KX-TDA200 and KX-TEx824 series PBXs must meet the latest version requirements shown in
the Data Converter tool. If the requirements are not met, you must use the Maintenance Console to upgrade the version to the latest
version, and then save the DSYS or xxxx.kea file.
Notice
• The following numbering plan settings are brought over during data conversion:
Feature Numbers, Other PBX Number, Extension Number, Quick Dial Number
• PBX voice data (e.g., ESVM, SVM, OGM) is not converted.
• Data conversion
for a SLC/LCOT card in the KX-NS500 is not supported; the number of ports in these
cards is too small.
• In the case of KX-TDA100/KX-TDA200, data that is not supported by the data conversion is shown in
the following table.
Unsupported Item Default Setting
Time Mode
Current time mode Location setting default
Time mode switching time (manual mode) Not Stored
Wired/Wireless extensions
Timed Reminder Not set
Station Lock Unlocked
Remote Station Lock Unlocked
Extension Call Charge Total Total cleared
Not Ready/Ready (Wrap-up) Wrap-up status cleared
LCS On/Off Location setting default
Room Status (Check In/Check out/Not Ready/
Cleaned Up)
Location setting default
Auto Answer Location setting default
Absent Message Status Not set
Saved Number Redial Number cleared
ICD Group Login Status (Login/Logout) Location setting default
Message Waiting Cancelled
Incoming Log Cleared
Outgoing Log Cleared
TAM Log Cleared
Personal Absent Message Message cleared
Installation Manual 189
5.3 Starting Web Maintenance Console