Panasonic KX-NS500 - Registering IP Telephones

5.8 Registering IP Telephones
5.8.1 Registering IP Telephones
After the
programming of the PBX and IP telephones is finished (refer to "5.7 Assigning Networking Information
to IP Telephones"), the IP telephones must be registered to the PBX. The procedure for registering IP
telephones differs according to the IP terminal registration mode specified during the Easy Setup Wizard. The
IP Terminal Registration Mode and IP-CS Registration Mode settings can be changed in the Site
Property—Main screen of the Web Maintenance Console (refer to "9.2.2 PBX Configuration—[1-1]
Configuration—Slot—System Property—Site—Main" in the PC Programming Manual). Refer to the following
table:
IP Terminals
IP Terminal Registration Mode/IP-CS Registration Mode
Full Automatic Mode
Extension Number
Input Mode
Manual Mode
IP-PTs
ü ü ü
KX-UT Series SIP
Phones
ü ü
*1
ü
Non-KX-UT series SIP
phones (including
P-SIP)
ü
*2
ü
*2
ü
IP-CSs
*3
ü
–
ü
ü: Available
*1
KX-UT series SIP phones will be registered automatically, in the same way as Full Automatic mode.
*2
Non-KX-UT series SIP phones must always be registered to the PBX manually, even if Full Automatic mode or Extension Number
Input mode is selected.
*3
For details about registering IP
-CSs, refer to the Installation Guide for the IP-CS.
Note
• For KX-UT series SIP phones, the SIP extension password is automatically set to "1234".
• For IP softphones, follow the same registration procedure as IP
-PTs.
Full Automatic Mode
If networking settings have been completed, when IP-PTs, KX-UT series SIP phones, or IP-CSs are connected
to the same network as the PBX, they will be registered automatically. No registration procedure is required.
Extension Number Input Mode
For IP-PTs
If networking settings have been completed, when IP-PTs are connected to the same network as the PBX,
they will be registered automatically, but extension numbers for the IP-PTs will not be set. Follow the procedure
below to register an extension number to complete registration.
1. After completing networking settings, connect the IP-PT to the same network as the PBX. The screen to
enter the extension number is displayed on the IP-PT.
Installation Manual 251
5.8.1 Registering IP Telephones