For details about operating the PROGRAM button and other buttons, refer to "For IP-PTs" in
"5.7.1 Assigning IP Addressing Information".
To exit from ECO mode, turn off the KX-NT500 series IP-PT, and then follow the procedure below.
KX-NT553/KX-NT556
Select "ECO Mode".
To start programming
Press "SETUP"
when it is displayed.
SETUP
Supply power
to the IP-PT.
Select "Off".
To end programming
Return to the
Menu screen.
Press
"STORE".
STORE
The IP-PT will reboot in
normal mode.
ENTER
KX-NT511/KX-NT551
Select "ECO Mode".
To start programming
Press "STORE".
Supply power
to the IP-PT
Press PROGRAM while
"Searching" is displayed.
To end programming
Press HOLD to return to
the Menu screen.
The IP-PT will reboot in
normal mode.
Press SP-PHONE.
To start programming
Select "Off".
To end programming
Note
• For KX-NT511 Users
For details about operating the PROGRAM button and other buttons, refer to "For IP-PTs" in
"5.7.1 Assigning IP Addressing Information
".
250 Installation Manual
5.7.6 ECO mode (KX-NT500 series only)
To Next Page
Loading...
