Panasonic KX-NS500 - De-Registering IP Telephones

5.8.2 De-registering IP Telephones
Note
For details about de-registering IP-CSs, refer to the documentation for the IP-CS.
De-registration of IP-PTs or KX-UT Series SIP Phones
1. Make
sure the IP Terminal
Registration Mode is set to
Manual.
a. Click Setup ® PBX Configuration ®
Configuration ® Slot ® System Property ®
Site ® Main.
b. In the Main tab, select Manual for IP Terminal
Registration Mode.
c. Click OK.
2.
a. Click Setup ® PBX Configuration ®
Configuration ® Slot.
b. Place the mouse cursor over the Virtual Slot, and
in the menu that appears, click Select Shelf.
c. For IP-PTs:
Move the mouse pointer over the V-IPEXT32 card
(Virtual 32-Channel VoIP Extension Card).
For KX-UT series SIP phones:
Move
the mouse pointer over the V-UTEXT32 card
(Virtual UT Extension Card).
A menu will be shown under the mouse pointer.
d. Click Port Property.
3. Click De-registration.
A dialogue box will appear. Registered extension
numbers and names are displayed on the left.
4.
a. Highlight numbers and names and click the right
arrow to select them for de-registration.
b. Click Next.
A dialogue box will appear.
c. Click Confirm.
• If the de-registration is successful, the dialogue
box will show "De
-registration succeed!
".
d. Click Close.
Once the IP-PT or
SIP phone is successfully de-registered, the status of the IP telephone will update to show
"None".
Installation Manual 257
5.8.2 De-registering IP Telephones