Panasonic KX-NS500 - Page 263

Programming the router at the main site
Port forwarding settings (Router – SBC)
Configure the following items for port forwarding in between the SBC and the router.
Application
LAN Side Port Number WAN Side Port Number
SIP Proxy NAT-SIP Proxy Port No.
(Use the same value as NAT - SIP
Proxy Server Port No. in step 5 of
"Programming the KX-NS500".)
NAT-SIP Proxy Port No.
(Use the same value as NAT - SIP
Proxy Server Port No.
in step 5 of
"Programming the KX-NS500".)
RTP (UDP) Start/End RTP (UDP) Port No.
(Use port numbers that are in the
range of the RTP ports that the
KX-NS500 uses.)
Start/End RTP (UDP) Port No.
(Use port numbers that are in the
range of the RTP ports that the
KX-NS500 uses.)
Make sure the RTP Start Port (UDP)
and the RTP End Port (UDP) specified
for the router are in the range of the RTP ports that the KX-NS500 uses. For
the range of RTP port numbers that the KX-NS500 uses, refer to "Port
Numbers for Optional DSP Card" in "8.6 Port Security".
Note
For information about configuring port forwarding on the router, refer to the documentation of the router.
Port forwarding settings
(Router – KX-NS500)
Configure the following items for port forwarding between the
KX-NS500 and the router.
Application LAN Side Port Number WAN Side Port Number
CWMP
HTTP CWMP (HTTP) Port No. for SIP-MLT
(Use the same value as in step 11 of
"Programming the KX-NS500".)
NAT - CWMP Server (HTTP) Port No.
(Use the same value as in step 5
of
"Programming the KX-NS500".)
HTTPS CWMP (HTTPS) Port No. for SIP-MLT
(Use the same value as in step 11 of
"Programming the KX-NS500
".)
NAT - CWMP Server (HTTPS) Port No.
(Use the same value as in step 5
of
"Programming the KX-NS500".)
SIP-MLT Data
HTTP Data Transmission Protocol (HTTP)
Port No. for SIP-MLT
(Use the same value as in step 11 of
"Programming the KX-NS500".)
NAT
- SIP-MLT Data Download Server
(HTTP) Port No.
(Use the same value as in step 5 of
"Programming the KX-NS500".)
HTTPS Data Transmission Protocol (HTTPS)
Port No. for SIP-MLT
(Use the same value as in step 11 of
"Programming the KX-NS500
".)
NAT
- SIP-MLT Data Download Server
(HTTPS) Port No.
(Use the same value as in step 5 of
"Programming the KX-NS500".)
Installation Manual 263
5.8.3 Installing SIP Phones at a Remote Site