c. Move the mouse pointer over the V-UTEXT32 card (Virtual UT Extension Card).
A menu will be shown under the mouse pointer.
d. Click
Port Property.
e. Click the Remote Place tab.
f. Configure the items shown below.
• Change the value to Remote (MRG) for Phone Location.
• Change the value to Enable for Web-MC Ability.
• Select a protocol (HTTP/HTTPS) for Protocol for Remote SIP-MLT.
Note
Select the same value as you selected for NAT - SIP Proxy Server Port No. in step 5 of
"Programming the PBX with Built-in Media Relay Gateway" in this section.
g. Click
OK.
7. Register the KX-UT series SIP phone. For details, refer to "5.8.1 Registering IP Telephones".
Note
• You can select HTTPS for Protocol for Remote SIP-MLT only when Phone Location is set as
Remote (MRG).
• If the KX-UT series SIP phone does not work normally, confirm whether the
KX-UT series SIP
phone can access the internet.
274 Installation Manual
5.8.4 Installing IP Phones at a Remote Site with a Built-in Media Relay Gateway
To Next Page
Loading...
