Panasonic KX-NT700

Changing the Language
1. Press [MENU].
2. Press [
] or [ ] repeatedly to select "Basic
Settings".
3. Press [ENTER] two times.
4. Press [ ] or [ ] repeatedly to select the desired
language.
5. Press [ENTER], then press [MENU].
Setting the Date & Time
Set
the unit's date and time setting before using the unit.
The date and time are shown on the display in standby
mode, and are displayed when playing conversations
that were recorded to an SD memory card.
1. Press [MENU].
2. Select "Basic Settings", then press
SELECT
.
3. Select "Date & Time", then press
SELECT
.
4. Using the keypad, enter 2 digits each for the year,
month,
day of the month, hour (24-hour format), and
minute.
Example: To enter "Jan. 23, 2008, 7:45 PM", press
[0801231945].
• If you make a mistake, press
to move
the cursor as needed, then enter the correct
number.
5. Press
SAVE
.
6. Press [MENU].
Note
• You
can select 12-hour or 24-hour time display
(see page 53).
• The date format varies by the selection made
for the "Language" setting. See page 52 for
details.
TEL Line Settings
Selecting the Available Lines
To use the TEL line, the "Line Selection" setting
must
be set to "IP + TEL". (This is the default setting.)
1. Press [MENU].
2. Press
LINE
.
3. Select "IP + TEL".
• When "Line Selection" is set to "IP +
PC" or "IP + PS", TEL calls cannot be made or
received.
4. Press
SAVE
.
5. Press [MENU].
Setting the Dial Mode
Set the dial mode to "Pulse" if the TEL line does not
support tone dialling.
1. Press [MENU].
2. Select "TEL Settings", then press
SELECT
.
3. Select "Dial Mode", then press
SELECT
.
4. Select "Pulse" or "Tone".
5. Press
SAVE
.
6. Press [MENU].
Document Version 2010/02 Operating Instructions 25
Preparation