• If
a pause is required when making a call on the
TEL line, press [REDIAL/PAUSE/
]
between digits as necessary.
3. Press [ ] or .
4. To end the call, press [ ].
Redialling
The last 10 calls made are stored in the redial list, in
order of newest to oldest call.
1. Press [REDIAL/PAUSE/
].
• The last call made is displayed.
2. Press [ ] or [ ] repeatedly to scroll through the
list.
• To erase the displayed item, press
.
• To exit the redial list, press [MENU].
3. When the desired entry is displayed, press [ ] or
.
Note
• The
line that was used to make each call in the
redial list ("IP" or "TEL") is shown in the
lower-right corner of the display. This line will be
used when the call is redialled.
Example:
The TEL line will
be used when
you redial this
number.
• If the "Line Selection" setting is not set to
"IP + TEL" (see page 32), TEL line calls
cannot be redialled.
• If the dialled number contains too many digits
(more than 32 digits for IP calls with IP-PBX
connection,
more than 128 digits for TEL calls),
it cannot be redialled correctly.
Entering Dialling Pauses
A pause is sometimes required when making calls on
the TEL line using a PBX or a long distance service. For
example, if you must dial "9" before dialling an outside
phone number, you probably wait (pause) after dialling
"9" until you hear a dial tone.
By pressing the [REDIAL/PAUSE/
]
button when
dialling, the unit will store the dialling pause along with
the phone number in the redial list. If you make a call
from the redial list later, the unit will dial the number wait
for the pre-programmed number of seconds (default: 3
s; see page 55) for each dialling pause you entered.
Example:
1. Press [9] (to access an outside line of a PBX).
2. Press [REDIAL/PAUSE/
].
• Press [REDIAL/PAUSE/ ] repeatedly to
create longer pauses. An additional pause is
inserted
each time [REDIAL/PAUSE/
] is
pressed.
3. Dial the phone number.
4. Press [ ] or .
Making a Call from the Phonebook
See page 38 to add entries to the phonebook.
1. Press
.
2. Press [ ] or [ ] repeatedly to scroll through the
phonebook entries.
• Entries are displayed in the following order
when [ ] is pressed.
Symbols®Numbers®Letters
• Press
the dial key corresponding to the desired
character, then press [
] or [ ] to scroll if
necessary.
• To exit the phonebook, press [MENU].
3. When the desired entry is displayed, press [
] or
.
Note
• The line that was selected when the entry was
stored in the phonebook (
"IP" or "TEL") is
shown in the lower-right corner of the display.
This line will be used when the entry is called.
Example:
The TEL line will
be used when
you call this
number.
• If the "Line Selection" setting is not set to
"IP + TEL" (see page 32), TEL line numbers
cannot be called.
Making Conference Calls
While
on a call, you can make another call and establish
a conference call (i.e., a 3-party call) including yourself
34 Operating Instructions Document Version 2010/02
Making and Answering Calls
To Next Page
Loading...
