Using a Portable
Station (PS) or
Computer
Using a Portable Station
(PS)
By connecting the unit to a PS, you can use the unit’s
microphones and speaker for calls made or received
with the PS.
Compatible Portable Stations (as of January,
2010)
– KX-TCA155 – KX-TCA175
– KX-TCA255 – KX-TCA256
– KX-TCA275 – KX-TCA355
– KX-TD7580 – KX-TD7590
– KX-TD7680 – KX-TD7684
– KX-TD7685 – KX-TD7690
– KX-TD7694 – KX-TD7695
– KX-TD7696
Note
• Product
availability may vary by country or area.
Line Selection (IP + PS)
1. Press [MENU].
2. Press
.
• When the operation mode is set to "USB
Audio",
is not displayed and you cannot
select a line type.
3. Select "IP + PS".
• When "Line Selection" is set to "IP +
PS", TEL calls cannot be made or received.
4. Press
.
5. Press [MENU].
Using a PS
1. Confirm
that "PS" is shown in the upper-right corner
of the display.
• You can change the selected line by pressing
the centre function button ([F2]).
The IP line is selected. The PS line is selected.
[F2] [F2]
• If you cannot select "PS", change the "Line
Selection" setting to "IP + PS" (explained
on this page).
2. Make or answer a call using the PS.
3. Connect the included
PS Cable to the [AUDIO IN/
OUT] jack of the unit (A), and to the headset jack
of the PS.
• Make sure the plug of the PS Cable is inserted
fully into the unit and PS, otherwise sound may
not be heard, or echoing and feedback may
occur.
• Place the PS as far away from the unit as
possible.
4. Press [
] to begin using the unit’
s microphones
and speaker.
• Press [
] again to turn off the microphones
and speaker.
5. Use the PS to end the call.
6. Turn off the unit’s microphones and speaker by
pressing [
].
Note
• For best performance, we recommend setting
the receiver volume of the PS as follows:
– 4-volume level models: level 3
– 6-volume level models: level 4
Document Version 2010/02 Operating Instructions 43
Using a Portable Station (PS) or Computer
To Next Page
Loading...
