Panasonic KX-NT700

Connecting Using the PC Cable
Connecting to a Computer
Connect the included
PC Cable to the [AUDIO IN/
OUT] jack of the unit (A), and to the microphone jack
(red plug; B) and headphone jack (green plug; C) of
the computer.
A
C
B
Note
• The microphone and speaker of the computer
cannot be used while the computer is
connected to the unit.
Line Selection (IP + PC
)
1. Press [MENU].
2. Press
LINE
.
• When the operation mode is set to "USB
Audio",
LINE
is not displayed and you cannot
select a line type.
3. Select "IP + PC".
• When "Line Selection" is set to "IP +
PC", TEL calls cannot be made or received.
4. Press
SAVE
.
5. Press [MENU].
Using a Computer
1. Confirm
that "PC" is shown in the upper-right corner
of the display.
• You can change the selected line by pressing
the centre function button ([F2]).
The IP line is selected. The PC line is selected.
[F2] [F2]
• If you cannot select "PC", change the "Line
Selection" setting to "IP + PC" (explained
on this page).
2. Press [
] to begin using the unit’
s microphones
and speaker.
• Press [
] again to turn off the microphones
and speaker.
3. Use the desired computer software to make or
answer a call.
4. Use the computer to end the call.
5. Turn off the unit’s microphones and speaker by
pressing [
].
Note
• Leave
at least 50 cm of space between the unit
and the computer.
46 Operating Instructions Document Version 2010/02
Using a Portable Station (PS) or Computer