Panasonic KX-NT700

Programming the Unit
Changing and
Confirming Settings
Settings can be programmed and confirmed from the
front panel. To use Conferencing Phone Manager
(found on the included CD-ROM) to program the unit
from a computer, see the Operating Instructions for
Conferencing Phone Manager for more details.
Changing Settings
Using the Front Panel
1. Press [MENU].
2. Press
[
]
or [
]
to select the desired programming
category, then press
SELECT
.
3. Press [
] or [ ] to select the desired parameter,
then press
SELECT
.
4. Adjust the settings as desired.
• To
cancel without changing any settings, press
[MENU].
5. Press
SAVE
.
6. Press [MENU].
Note
• When programming the unit from the front
panel, the current setting is indicated on the
display by "ü".
• To return to the previous screen, press
[BACK].
• If
you do not press any buttons for 1 minute, the
unit will return to standby mode.
• The following parameters cannot be
programmed, and are therefore not displayed,
when the unit is in use.
– Operation Mode
– Language
– Date & Time
– Time Format
– Ringer Volume
– Ringtone
– IP Network Settings (all parameters)
– Protocol Settings (all parameters)
– VoIP Settings (all parameters)
– QoS Settings (all parameters)
Additionally, the following parameters cannot
be programmed, and are therefore not
displayed, when the TEL, PS, or PC line is in
use.
– Line Selection
– TEL Settings (all parameters)
Using
Conferencing Phone Manager
To use Conferencing Phone Manager (found on the
included CD-ROM) to program the unit from a
computer, see the Operating Instructions for
Conferencing Phone Manager for more details.
Restarting the Unit
After changing the following parameters, the unit must
be restarted in order for the new settings to take effect.
(Data is not erased when the unit is restarted.)
– Operation Mode (page 51)
– IP Address Mode (page 56)
– IP Address (page 56)
– Subnet Mask (page 56)
– Default Gateway (page 56)
– SIP Ext. No. (page 57)
– SIP Password (page 57)
– SIP User Domain Name (page 57)
– SIP Proxy Server IP Address (page 57)
– SIP Proxy Server Port Number (page 57)
– SIP Registrar IP Address (page 58)
– SIP Registrar Port Number (page 58)
– Hold Method (page 58)
– SIP Signalling Port Number (page 59)
– VLAN ID (page 59)
– VLAN Priority (page 59)
– SIP ToS Field (page 60)
– RTP ToS Field (page 60)
1. Press [MENU].
2. Select "System Options", then press
SELECT
.
3. Select "Reboot", then press
SELECT
.
4. Select "Yes", then press
SELECT
.
Note
• To
use Conferencing Phone Manager to restart
the unit, see the Operating Instructions for
Conferencing Phone Manager for more details.
Document Version 2010/02 Operating Instructions 47
Programming the Unit