Panasonic KX-TC1891B - Selecting the Line Mode.19

Selecting the Line Mode
If the line is connected to a low voltage system such as a PBX, set to “B”
Otherwise the [TALK] and/or (DIGITAL SP-PHONE] button(s) may not
operate properly Both lines are preset to “A”
Make sure the unit is in the standby mode.
Press [FUNCTION/EXIT/CH]
► Save
directory
Ringer volume
TA ► = Y es
2 Press B or® repeatedly until the arrow ( ► p r o gram
points to “Program” points to “Program”
Press FWD/EDIT B (Yes key)
► = Y e s
► S a ve DIRECT#
Set flash tame
▼ A ► = Y es
Press ©or® repeatedly until the arrow l^et line"mode
points to Set line mode Set dial mode
Press FWD/EDIT B (Yes key)
Press B (Lmel) or Q (Lme2) to select
the desired line
Press B or B to select “b” or “a”
Press FWD/EDIT B (Save key)
•A beep sounds
•To program the other line, start again from
step 4
•To return to the standby mode, press
I FUNCTION/EXIT/CH)
Set dial mode
TA ► = Y es
Line mode
T=Linel A=Lme2
Line
mode
Lmel A
TA
► = S a ve
Line mode
Lmel B
•You can exit the programming mode any time by pressing (FUNCTION/EXIT/CH)
19
Preparation