Panasonic KX-TC1891B - Programmable Functions.21

Programmable Functions
►
You can program the following function items using the handset near
the base unit The display shows the programming instructions See the
corresponding pages for function details
Make sure the unit is in the standby mode
Press [ FUNCTION/EXIT/CH)
\
<Function menu>*
To store an item in the directory (p 50)
To select the ringer volume (p 23)
J Press FWD/EDIT ®
<Function menu>*
► S a ve directory
Ringer volume
Program
( -
\
► Save DIRECT#
Set
flash time
Set line mode
Set
dial mode
Line selection
Incoming call
Talk
switching
TAD program
V
_I_J
To store a phone number in the DIRECT button
(P 47)
To select the flash time (p 65)
To select the line mode (p 19)
To select the dial mode (p 18)
To change the line selection (p 66)
To set the incoming call tone (p 67)
To set the auto talk feature (p 22)
To program answering system functions {p 27)
During programming
*To select a desired function item, press [ ▼ ] or Q repeatedly until the
arrow points to the item Then press FWD/EDIT ( ► ) to go to the next step
• If the handset displays “No link to base Place on cradle and try
again ” and an alarm tone sounds, move closer to the b ase unit and try again
•You can exit the programming mode any time by pressing [ F U N CTION/EXIT/CH]
• If you do not press any buttons for 60 seconds, the unit will return to the standby
mode
21
Preparation