Panasonic KX-TC1891B - Erasing Messages.73

Erasing Messages
The unit will announce the remaining recording time after playback, if it is
less than 5 minutes New messages cannot be recorded when
—“Memory full” is heard
—“Message full” is displayed on the base unit
—the ANSWER ON indicator flashes rapidly
Erase some, or all, of the messages We recommend you erase
unnecessary messages after each playback
Erasing a specific message
Press [ERASE/CLEAR] while the message you want to erase is being
played
•The unit erases the message
•A short beep will sound and the unit will continue to play the next message
Erasing all messages
All recorded messages, except the greeting message(s), can be erased at
one time
1
a) To erase all messages on both lines, press (LINE SELECT)
repeatedly until "mni ” is displayed
b) To erase all messages on either line, press (LINE SELECT)
repeatedly until “Dl” or “ IQ" is displayed
Press (ERASE/CLEARJ
•“Press ERASE again to erase all messages”
is heard
Within 5 seconds, press
[ ERASE/CLEAR 1 again
•A beep sounds, and the selected line
and “No messages” are heard
•The base unit display shows
“0 message”
•The information in the Caller List will not be erased To erase Caller List
information, see page 45
73
Answering
System