Panasonic KX-TC1891B - Incoming Call Tone.67

Incoming Call Tone
While one line is being used, you can be informed if another call arrives
on the other line by two tones This incoming call tone can be set/deleted
by programming Your phone comes from the factory set to “2”
Make sure the unit is m the standby mode.
A Press [FUNCTION/EXIT/CH]
2 Press ® or ® repeatedly until the arrow
points to “Program”
Press FWD/EDIT ® (Yes key)
► P r o gram
▼ A
► =Yes
4 Press (3 or (® repeatedly until the arrow
points to “incoming call
Press FWD/EDIT® (Yes key)
•The current setting is displayed
On The incoming call tone will be heard
for as long as the other line rings
2 The incoming call tone will only be heard
2 times (factory preset)
Off The incoming call tone will not be heard
Line selection
► i n c o ming call
▼ A ^=Yes
Incoming call
tone On
YA ► = S a ve
6 Press ® or ® repeatedly until the
desired setting is displayed
7
Press FWD/EDIT ®) (Save key)
•A beep sounds
•To return to the standby mode, press
(FUNCTION/EXIT/CH)
Incoming call
tone 2
▼ A _ ► = Save
Incoming call
tone 2
•You can exit the programming mode any time by pressing [ FUNCTION/EXIT/CH)
67
Cordless
Telephone