Panasonic KX-TC1891B - Setting the Remote Code.75

Setting the Remote Code
The remote code prevents unauthorized people from accessing your unit
and listening to your messages. Choose any 2-digit number (00-99).
The factory preset remote code is “11". If you do not program your own
remote code, you can use “11”.
Make sure the unit is in the standby mode.
-j Press \ FUNction/exit/chI .
2 Press (3 or ® repeatedly until the arrow
points to “Program”.
2 Press FWD/EDIT ® (Yes key).
4 Press B or S repeatedly until the arrow
points to “TAD program”.
5 Press FWD/EDIT ( ► ) (Yes key).
•The base unit display shows the function menu
for the answering system.
6 Press (T).
•The current setting is displayed on the base
unit.
7 Enter a remote code using a 2-digit
number (00-99).
8 Press FWD/EDIT ® (Save key).
•A beep sounds. _
•To return to the standby mode, press (FUNCTION/EXIT/CHl
Base unit display
• If 6 beeps sound during programming, a wrong key was pressed. Enter the
correct number.
To check the remote code
Repeat steps 1 to 6.
•The current remote code is displayed on the base unit. When finished, press
fFUNCTION/EXIT/CHj .
75
Answering
System