Station Programming 2-3
2.1 Station Programming Instructions
To confirm the assigned function data
— Be sure that you are in the Station Programming mode: Press [PROGRAM] [9] [9].
1. Enter the programming access number* (0 through 9, 01
through 03, 1 and #).
• Each number corresponds to the data as follows:
- 1: Preferred Line Assignment — Outgoing
- 2: Preferred Line Assignment — Incoming
- 3: Full One-Touch Dialling Assignment
- 4: Intercom Alerting Assignment
- 5: Call Waiting Tone Type Assignment
- 6: Self-Extension Number Confirmation
- 8: Charge Fee Reference
- 9: Handset/Headset Selection
- 01: Remote Station Lock Control (— Operator only)
- 02: CO Incoming Call Information Log Lock Clear
(— Operator only)
- 03: Live Call Screening Password Control† (— Operator
only)
- #: Station Programming Data Default Set
- 1: Live Call Screening Mode Setting†
• The display shows the programmed data.
<Example>
When you press [5], the display shows:
(— Call Waiting tone is now programmed to Tone 1)
2. Press the HOLD (END) button.
• The display shows the initial programming mode.
— To exit from Station Programming mode: Press [PROGRAM] or lift the handset.
— If you wish to change the data, follow the programming procedure explained in this
section.
*
A programming access number is required to program/confirm the function data by Station Programming.
† Available when the Digital Super Hybrid System is connected to a Digital Proprietary Telephone capable
Panasonic Voice Processing System (one that supports digital proprietary telephone integration; e.g. KX-
TVP100).
1
2
To Next Page
Loading...
