Panasonic KX-TD816E - Basic Operations; DPT Features; DSS Console Features; Operator Service Features

8-2 Quick Reference
8 Quick Reference
❐ Making Calls
— Intercom Calling
•Off-hook.
•Dial the extension number, or press a DSS
button.
— Outward Dialling
•Off-hook.
•Dial 9 or 81 through 88, or press a CO
button.
- 9 : Line Access, Automatic
- 81 – 88 : Line Access, CO Line Group
- CO : Line Access, Individual
•Dial the phone number.
❐ Receiving Calls
•Off-hook.
OR
•Press a flashing CO button directly
(Answering, Direct CO Line), or a flashing
INTERCOM button directly.
● To enter programming mode
(Be sure the telephone is idle and on-
hook.)
Press: PROGRAM 9 9
● To exit programming mode
Press: PROGRAM or lift the handset
❐ Call Waiting Tone Type Assignment
•Enter the programming mode.
•Dial 5.
•Dial 1 or 2.
- 1 : Call Waiting Tone 1
- 2 : Call Waiting Tone 2
•Press STORE button.
•Exit the programming mode.
Off-hook: Lift the handset or press the
SP-PHONE/MONITOR button.
On-hook: Hang up or press the
SP-PHONE/MONITOR button.
This list is divided into the following eight sections. Refer to each section as needed.
1.) Basic Operations
2.) Station Programming
3.) User Programming (Manager Programming)
4.) DPT Features
5.) Operator Service Features
6.) Special Display Features
7.) DECT Portable Station Features
8.) DSS Console Features
9.) SLT and ISDN Telephone Features
•
When setting “Idle Line Preference — Outgoing,” “No Line Preference — Outgoing,” or “Prime
(CO Line) Preference,” press the INTERCOM button after going off-hook to activate the following
operations. (Pressing the INTERCOM button directly without going off-hook is also available.)
1 2
Basic Operations Station Programming
<Note>