Panasonic KX-TD816E - Voice Mail (VM) Transfer Button

Station Programming 2-31
2.2 Station Programming
Voice Mail (VM) Transfer Button (Assignment)
Allows you to assign a Flexible (CO, DSS, PF) button as the VM Transfer button.
— Be sure that you are in the Station Programming mode: Press [PROGRAM] [9] [9].
1. Press the desired Flexible (CO, DSS, PF) button which you
wish to assign as the VM Transfer button.
2. Dial 82.
• The display shows:
3. Dial the extension number of the Voice Mail.
• The display shows:
(— xxxx: VM extension
number)
• To erase an incorrect entry, press the CLR (S2) button or
the TRANSFER (CLEAR) button.
(The TRANSFER button becomes the CLEAR button when using the
overlay.)
4. Press the STORE button.
• The STORE indicator light turns on.
• The display shows the initial programming mode.
— To exit from Station Programming mode: Press [PROGRAM] or lift the handset.
Conditions
• You cannot enter a non-existent extension or a floating number.*
• Through System Programming, “VM command DTMF Set” and “Station Hunting
Type” must be programmed to match the operation of your Voice Processing System.
Programming References
• System Programming — Installation Manual
[106] Station Hunting Type
[114] VM Command DTMF Set
* Floating Number (FN) is a virtual extension number for resources to make it appear to be an extension.
Refer to the Installation Manual.
1
2
4
AUTO DIAL
STORE
3
VM extension number
8
2
VTR-
CLR
VTR-xxxx
CLR