Panasonic KX-TD816E - Account Code Set

2-14 Station Programming
2.2 Station Programming
Account Code Set
Allows you to assign the account code.
— Be sure that you are in the Station Programming mode: Press [PROGRAM] [9] [9].
1. Dial 8.
2. Enter the ID Code (4 digits).
• The display shows:
• To erase an incorrect entry, press the CLR (S2) button.
3. Dial 7.
4. Dial the location number (01 through 40) or press the NEXT
(S3) button until the location number will be designated.
• If the account code has not been assigned, the display
shows “Not Stored.”
5. Press the CLR (S2) button.
• The message of the display disappears.
6. Dial the new account code (5 digits).
• The display shows:
(— xx: location number)
(— aaaaa: account code
number)
• To erase an incorrect entry, press the CLR (S2) button.
7. Press the STORE button.
• The display shows the new account code.
8. Press the HOLD (END) button.
• The display returns to step 3.
9. Press the HOLD (END) button again.
• The display shows the initial programming mode.
— To exit from Station Programming mode: Press [PROGRAM] or lift the handset.
Charge Meter
xx:aaaaa
CLR NEXT
1
2
3
4
5
8
ID Code
location number
S 1
S 2
S 3
CLR
7
AUTO DIAL
STORE
8
6
account code
HOLD
HOLD
9
7